11. Cylinder block/head Valve Disassembly of Valve Measurement of Valve Stem End Note)Refer to Chapter 6 (Procedure of Disassembling an Engine) 1. Remove the valve. 1. Mount the valve to the cylinder head. 2. Perform the zero point adjustment of the meter. 3. Measure the valve stem end (A). Measurement of Inside Diameter of Valve Guide A 1. Mount the valve guide to the cylinder head. 2. Set the meter. 3. Measure the inside diameter of the valve guide. EDL022093A A B 1) Measure 8ea intake valve stem ends. 2) The standard measurement value of the intake valve stem end is within the range of 17.0 ~ 17.5 mm. 3) Measure 8ea exhaust valve stem ends.
EDL022092A 4) The standard measurement value of the exhaust 1) Measure total 6 points of the valve guide to the valve stem end is within the range of 17.1 ~ 17.6 mm. vertical direction (B) and the horizontal direction (A): top, middle, and bottom. 2) Measure 16ea valves; 8ea intake valves and 8ea exhaust valves. 3) The standard measurement value of the valve guide inside diameter is within the range of 7.0 ~ 7.015 mm. Item Specified Value Valve guide inside diameter 7.0 ~ 7.015 mm 11 - 18 Item Specified Value Intake valve stem end 17.0 ~ 17.5 mm Exhaust valve stem end 17.1 ~ 17.6 mm