13. Others/Driving System 1) Insert the piston ring to the cylinder top at a right 4) The standard measurement value of the step angle with the wall. height of the piston top side is within the range 2) Measure the piston ring end gap with the gap gauge (A). of 0.24 ~ 0.52 mm. 3) Measure the gaps of the top ring, the 2nd ring, and the oil ring. 4) The standard measurement values of the gap of the piston ring end is within the range of 0.20 ~ 0.35 mm for the top ring, 0.55 ~ 0.70 mm for the CAUTION 2nd ring, and 0.20 ~ 0.40 mm for the oil ring.
Select the cylinder head gasket class based on the average of step heights of the piston top side by measuring average value of step heights at 8 points. For the cylinder gasket class, refer to #19 of Procedure of Assembling an Engine of General Information in Chapter 6. The front engine direction (F) is the water pump direction and the rear engine direction (R) is the flywheel direction. CAUTION Be careful not to damage the cylinder with the gap gauge when measuring the gap of the piston ring end. Assembly of Piston 1. Attach the piston. Note)Refer to Chapter 6 (Procedure of Assembling an Engine). Measurement of Step Height of Piston Top Side 1.
Perform the zero point adjustment of the meter based on the top surface of the cylinder block. 2. Measure the step height of the piston top side. 1) Adjust the piston to position on the top dead point. 2) Measure the step height on A and B on the piston top side based on the cylinder block 3) Adjust the other pistons to position on the top surface. dead point and measure 8 points. 13 - 12 Item Specified Value Step height of piston top side 0.24 ~ 0.52 mm Item Spe cified Value Gap of top ring 0.20 ~ 0.35 mm Gap of 2nd ring 0.55 ~ 0.70 mm Gap of oil ring 0.20 ~ 0.40 mm A F R B EDL013101A A F R B EDL013101A