. OPERATION OPERATION CHECK OIL LEVEL IN ENGINE OIL PAN, ADD OIL WARNING Parts and oil are at high temperature immediately after the engine is stopped and may cause serious burns. Wait for the oil temperature to go down before performing this operation. the the 6. If the oil level is correct, tighten the handle of the oil filler cap securely. 3 - 72 CHECK DUST INDICATOR 1. Check that the red line in indicator (1) does not indica (0.076 kgf/cm2, 1.1 PSI). 2. If the red line indicates 0.00 kgf/cm2, 1.1 PSI), clean or immediately. For details of the metho "CHECK, CLEAN OR RE 4-21)". 3. After checking, cleaning, o indicator (1) to return the re the transparent portion of dust 1. i 2. I i 3. i 1.
dust ndicator (1) does not indica te 0.0075 MPa (30 INCHES H 2O) (0.076 kgf/cm2, 1.1 PSI). 75 MPa (30 INCHES H2O) (0.076 2. I f the red line indicates 0.00 kgf/cm2, 1.1 PSI), clean or mmediately. For details of the metho replace the air cleaner element d of cleaning the element, see For see "CHECK, CLEAN OR RE 4-21)". After checking, cleaning, o PLACE AIR CLEANER (PAGE r replacing, press the top of dust d line to its original position. 3. ndicator (1) to return the re 1. 2. Open the engine hood cov dipstick (G). Take out the dipstick (G) an er and check the oil level with d wipe off the oil with cloth. 3. 4.
I Fully insert dipstick (G) into The oil level should be bet ENGINE STOPPED side of filler pipe (F), then remove it. ween the H and L marks on dipstick (G). , add oil through oil filler (F). f the oil is below the L mark 5. I f the oil is above the H mark , remove drain plug (1), and loosen drain valve (2) to drain the engine oil level again. excess engine oil, then check the