. OPERATION OPERATION OPERATIONS, CHECKS AFTER STARTING ENGINE BREAKING-IN THE MACHINE CAUTION WARMING-UP OPERATION 1. Immediately after starting the engine, do not operate the accelerator pedal or dump body for the time given below. Even after this time has passed, avoid sudden acceleration of the engine for 5 minutes. Normal temperature: 10 seconds Cold temperature: 15 seconds or more When first starting engine after changing engine oil or replacing engine oil filter: 20 seconds 2. After the warming-up operation, check that the machine monitor is normal. If there is any abnormality, carry out maintenance or repair. When the AISS LOW switch is revolution is automatically maintained.
CANCELING DUMP BODY HOLD CONDITION WARNING 3 - 84 Your Komatsu machine has been thorough ly adjusted and tested before shipment. However, operating th e machine und er severe conditions at the beginning can adversely affect the performance and shorten the machine life. tial 100 hours (as indicated by the service meter). cautions described in this manual. Be sure to break-in the machine for the ini During break-in operations, follow the pre Idle the engine for 5 minutes after starting it up. r at high speeds. Avoid operation with heavy loads o Immediately after starting the engin e, avoid sudden starts, sudden acceleration, unnecess ary sudden sto ps, and sudden changes in direction.
NOTICE til the warming-up operation has been completed. dle continuously for more than 20 minutes. Do not accelerate the engine suddenly un Do not run the engine at low idle or high i If it is necessary to continue to run the en gine at idle, apply a load from time to time or run the engine a t a mid-range s After starting the engine, do not imme diately start operations. First, perform the following op erations and c hecks. the AUTO position and the engine water temperature is still low, high idling ined. is still low, hig h idling n the steering operation, flashing of lights, sound of hor n, exhaust ga s color, ality is found, repair it.
If the HOLD is canceled when the dump b ody is raised, the body will go down under its own weight. This is very da ngerous. Always lower the dump body before stopp ing the engine. After the engine has been started, if th e dump lever is operated to HOLD, the dump body is h eld in position until the lever is operated to FLOAT, RAISE, o r LOWER. After starting the engine, the body pil ot lamp lights up, so operate the dump lever from HOL D to FLOAT to cancel the body hold condition. With this op lamp goes out. eration, when the dump body moves to the FLOAT condition, the body pilot ndition, the bo dy pilot