Komatsu — CHECK, CLEAN AND REPLACE AIR CLEANER

. MAINTENANCE SERVICE PROCEDURE 4 - 22 CLEANING OR REPLACING OUTER ELEMENT 1. 2. 3. 4. a 5. 1. Release l ock ( 2) of cover ( 3), then remov e the cover. 2. Remove outer element (5) 3. Clean the air c leaner body interior and th e cove 4. Direct dry compressed air ( less then 0.69 MPa ( 7 kgf/cm 2, 99.4 PSI)) alon g th e folds of the element from t he inside. Next, blow with a ir a long the folds fr inside. om the outside, then blow with air air gain fro m the 5. Remove evacuator valve ( 4) and clean it with c ompressed air. After cleaning , install it ag ain. NOTI After cleaning, thinn er parts ar e found, replace th When cleaning the e lement, do no t hit it or beat it against anything.

Do n ot use any element if the elem ent folds or gask et or se al are damaged. f small holes 6. I nstall the cleaned elemen t, then install c over (