. OPERATION TROUBLESHOOTING STARTING THE ENGINE CAUTION (+) according to the following 3 - 183 Check that the gearshift levers on both the normal machine and problem machine are at the P (Parkin g) position. Check also that all 1. Make sure the clips are fi rmly connected to the battery terminals. l machine and run it at high idle speed. 2. Start engine of the norma l machine and run it at high idle s 3. Turn the starting switch o f the problem machine to the START position and start the If the engine doesn't start at first, try again after 2 minutes o r so. DISCONNECTING THE BOOS TER CABLES , disconnect booster cables in t ere connected.
After the engine has started reverse order in which they w 1. Remove one clip of boost the problem machine. 2. Remove the other clip of b terminal of the normal ma 3. Remove one clip of boo terminal of the normal ma 4. Remove the other clip of b terminal of the problem m 1. Remove one clip of boost er cable (B) from the engine block 2. Remove the other clip of b ooster cable (B) from the negative chine. ster cable (A) from the positive ( chine. 4. Remove the other clip of b ooster cable (A) from the positive ( achine. IF THE GEAR SHIFT LEVER OF THE TRANSMISSION HAS ANY TROUB I f e transmission has any trouble, operate the machine ac 1.
Decelerate the machine with the brake and stop it on a safe 2. Set the gear shift lever to N (NEUTRAL) or P (PARKING). 3. In some trouble modes, t he gear is not shifted even if the g ear shift lever is operated. In this case, perform the f If the character display according to the following 1) Set the gear shift leve 5 seconds. 2) By moving the gear sh to its flashing, the ma ift lever to any of F5 to F8 or any of R1 to R4 after the shift ind icator's lighting changes chine travels at fixed gear speed o f F2 or R2. Move the mac hine to a safe place. pe function does not work in some cases depending on the