MAN Nutzfahrzeuge Aktiengesellschaft — V-belts

V-belts V-belts Checking condition D Check V-belts for cracks, oil, overheating and wear D Change demaged V-belts If, in the case of a multiple belt drive, wear or differing tensions are found, always replace the complete set of belts. Checking tension Use V-belt tension tester to check V-belt tension. D Lower indicator arm А into the scale D Apply tester to belt at a point midway between two pulleys so that edge of contact surface Б is flush with the V-belt D Slowly depress pad В until the spring can be heard to disengage. This will cause the indica- tor to move upwards 1 If pressure is maintained after the spring has dis- engaged a false reading will be obtained!

2 Reading of tension D Read of the tensioning force of the belt at the point where the top surface of the indicator arm А intersects with the scale D Before taking readings make ensure that the indicator arm remains in its position If the value measured deviates from the setting value specified, the V-belt tension must be cor- rected. 3 130 Tensioning forces according to the kg graduation on the teste Drive belt New installation When ser- width Installation After 10 min. run- ning time vicing after long run- ning time 2/3VX 90−100 70−80 60 3/3VX 135−150 105−120 90