MAN Nutzfahrzeuge Aktiengesellschaft — Repairing coolant pump with high-temperature and low-temperature parts

Repairing coolant pump with high-temperature and low-temperature parts Reassembling coolant pump Fig. 8 Press in water pump bearing. Fit the circlip. Note: If you change the seals always install a new shaft and axial face seals. 8 Fig. 9 Press boss flush on to bearing shaft. Use suitable plates (80.99614−0027 and 80.99606−0628) to brace the bearing shaft. 9 Fig. 10 Turn coolant pump over (for this support bearing shaft with 80.99606−0629) and press in new axial− face seal (Fig. 1, no. 12) using mandrel (80.99606−0252) until mandrel is in contact. Observe installation note for seal on page 60. 10 Fig. 11 Press in counterring (arrow) with a suitable pres- sing tool (may be possible by hand).

Install mechanical seal while “wet”, i.e. to install it, coat holding sleeve and water pump shaft with a mixture of either 50% water and 50% cleaning spirit or 40% to 50% antifreeze agent as per MAN 324 and water. 11 56