GETTING TO KNOW YOUR INSTRUMENT PANEL 43 I NSTRUMENT C LUSTER D ISPLAY M ENU I TEMS Push the MENU button briefly to return to the menu screen or hold the MENU button down to return to the standard screen without storing. Buzzer Volume With this function, the volume of the acoustic signal which accompanies the display of failure/ warning can be adjusted according to seven levels. Speed Beep This function is used to set a speed limit (MPH or km/h); the driver is alerted when this limit is exceeded. To cancel the setting: 1. Briefly push the MENU button, “ON” will flash in the display. To set the desired volume: 1. Push the MENU button, the previously set volume level will flash on the display.
To set the desired speed limit: 2. Push the down arrow button, “OFF” will flash in the display. 2. Push and release the up or down arrow button to adjust. 3 1. Push the MENU button briefly. The display will show the wording (SPEED BEEP) and the unit (MPH) or (km/h) previously set. 3. Push the MENU button briefly to return to the menu screen or hold the MENU button down to return to the standard screen without storing. 3. Push the MENU button to return to the menu screen or hold the MENU button down to return to the standard screen without storing. 2. If the function is on, push and release the up or down arrow button to select the required speed limit and then push MENU to confirm.
Trip B Data This function can be used to activate (On) or deactivate (Off) the Trip B display (Partial Trip) Ъ page 44. Seat Belt Buzzer Only shows in the instrument cluster display if the seat belt reminder was previously deactivated by an authorized dealer. NOTE: The speed may be set in the range from 20 to 125 mph (30 to 200 km/h) according to the previ- ously chosen unit. The setting will increase/decrease by five units each time the up or down arrow button is pushed. Hold down the up or down arrow button to automatically increase/decrease the setting rapidly. Complete the adjustment when you approach the desired value. To switch the function On/Off: 1. Push the MENU button briefly.
The display will flash On or Off according to the previous setting. NOTE: This is a one-time occurrence to enable the acoustic signal. 2. Push and release the up or down arrow button to select. Push the MENU button briefly to return to the menu screen or hold the MENU button down to return to the standard screen without storing.