STRUCTURE AND FUNCTION CLSS 2. During compound operations, if the load pressure becomes lower than the other actuators, and the oil flow tries to increase, compensation is received. In this case, the load pressure at the other actuator end be- comes higher and the oil flow tries to decrease. Operation During compound operations, if the load pres- sure becomes higher at the other actuator end, the oil flow in actuator circuit A tries to increase. In this case, LS pressure P LS at the other actua- tor end also becomes higher.
LS pressure P LS then pushes shuttle valve (4) of pressure com- pensation valve (1) to the right in the direction of the arrow, so the oil passes through passage inside piston (3) and flows into the spring cham- ber. As a result, piston (3) and valve (5) are pushed to the right in the direction of the arrow, the out- let port end of pump circuit Pp is closed, and outlet port pressure P LS (spool meter-in down- stream pressure) becomes the same as the outlet port pressure of the other actuator.
Pump discharge pressure Pp (spool meter-in upstream pressure) is the same as between all actuators, so pump discharge pressure Pp and outlet port P PA become the same as all the spools that are operated. Therefore, the flow of oil from the pump is distributed in proportion to the area of the opening of each spool. 1. Pressure compensation valve 2. Spring 3. Piston 4. Shuttle valve 5. Valve Pp : Pump circuit (pressure) P PA :Pump outlet port circuit (pressure) P LS :LS circuit (pressure) A : Actuator circuit (pressure) T : Tank circuit (pressure) 10-78