TESTING AND ADJUSTING STANDARD VALUE TABLE FOR ELECTRICAL PARTS 20-18 Sys- tem Name of component Connector No. Inspec- tion method Judgement table Measurement conditions Monitor system Engine speed sensor E07 (male) Measure current If the condition is as shown in the table below, it is normal Between (1) - (2) 500 - 1,000 Ω Between (2) - chassis Min. 1 MΩ 1) Turn starting switch OFF. 2) Disconnect connector E7. Measure voltage If the condition is as shown in the table below, it is normal Between (1) - (2) 0.5 - 3.0 V 1) Start engine. 2) Insert T-adapter. Adjust 1) Screw in the speed sensor until it contacts the ring gear, then turn back 1 ± 1/6 turns.
2) It must work normally when adjusted as above. Coolant level sensor P08 (male) Measure current If the condition is as shown in the table below, it is normal Above LOW level in reservoir tank Max. 1 Ω Below LOW level in reservoir tank Min. 1 MΩ 1) Turn starting switch OFF. 2) Disconnect connector P08. 3) Insert T-adapter into connector at sensor end. Engine oil level sensor P05 (male) Measure current If the condition is as shown in the table below, it is normal Raise float Max. 1 Ω Lower float Min. 1 MΩ 1) Turn starting switch OFF. 2) Disconnect connector P05. 3) Drain oil, then remove sensor. Between (1) - (2) 500 - 1,000 Ω Between (2) - chassis Min.
1 MΩ Between (1) - (2) 0.5 - 3.0 V Above LOW level in reservoir tank Max. 1 Ω Below LOW level in reservoir tank Min. 1 MΩ Raise float Max. 1 Ω Lower float Min. 1 MΩ