Komatsu — TESTING AND ADJUSTING HYDRAULIC PRESSURE IN WORK EQUIPMENT, SWING, TRAVEL CIRCUIT

TESTING AND ADJUSTING TESTING AND ADJUSTING HYDRAULIC PRESSURE IN WORK EQUIPMENT, SWING, TRAVEL CIRCUIT 2. ADJUSTING Main relief valve 1) Adjusting high set pressure end i) Loosen locknut (5). # Check that elbow (6) can move. ii) Loosen locknut (3), then turn holder (4) to adjust. # Turn the holder to adjust as follows. To INCREASE pressure, turn CLOCKWISE. To DECREASE pressure, turn COUNTERCLOCKWISE. # Amount of adjustment for one turn of holder: 12.6 MPa {128 kg/cm 2 } Locknut: 58.8 ± 4.9 Nm {6 ± 0.5 kgm} # When the high-pressure end is ad- justed, the low-pressure end also changes, so adjust the low-pressure end also. 2) Adjusting low set pressure end i) Loosen locknut (5).

# Check that elbow (6) can move. ii) Loosen locknut (7), then turn holder (8) to adjust. # Turn the holder to adjust as follows. To INCREASE pressure, turn CLOCKWISE. To DECREASE pressure, turn COUNTERCLOCKWISE. # Amount of adjustment for one turn of holder: 12.6 MPa {128 kg/cm 2 } Locknut: 44.1 ± 4.9 Nm {4.5 ± 0.5 kgm} # Normally, there is a pressure of approx. 1.3 MPa {13 kg/cm 2 } or less applied to port PR , but at high-pressure setting the pressure is approx. 2.9 MPa {30 kg/cm 2 ). Swing motor safety valve Loosen locknut (9), then turn adjustment screw (10) to adjust. # Turn the adjustment screw to adjust as follows. To INCREASE pressure, turn CLOCKWISE.

To DECREASE pressure, turn COUNTERCLOCKWISE. # After completion of adjustment, repeat the proce- dure in Item 1 to check again. # The safety valve set pressure can be adjusted only for the swing motor. Do not try to adjust the setting for anything except the swing motor. 20-28