Komatsu — TESTING AND ADJUSTING PC VALVE OUTPUT PRESSURE ( SERVO PISTON INPUT PRESSURE)

TESTING AND ADJUSTING TESTING AND ADJUSTING PC VALVE OUTPUT PRESSURE (SERVO PISTON INPUT PRESSURE) TESTING AND ADJUSTING PC VALVE OUTPUT PRESSURE (SERVO PISTON INPUT PRESSURE) Measuring # Oil temperature when measuring 45 - 550C Measure the oil pressure when the circuit is relieved in the pressure rise mode. 1) Remove pressure measurement plugs (1) and (2) (Thread dia.=10 mm, Pitch=1.5 mm), and install oil pressure gauge C1 . # Install a 39.2 MPa {400 kg/cm 2 } gauge to the servo valve end, and a 58.8 MPa {600 kg/ cm 2 } gauge to the pump outlet port end. 2) Turn the swing lock switch ON. 3) Set the working mode to heavy-duty operation mode.

4) Run the engine at full throttle, turn the knob switch ON, and measure the oil pressure when the arm (IN) circuit is relieved. # Check that the servo piston input pressure is 1/2 of the pump discharge pressure. [Reference] If there is any abnormality in the LS valve or servo piston, the servo piston input pressure will be 0 or al- most the same as the pump discharge pressure. 20-29