TESTING AND ADJUSTING TESTING AND ADJUSTING PC VALVE OUTPUT PRESSURE (SERVO PISTON INPUT PRESSURE) Adjusting # If the load becomes larger and the engine speed drops, or if the engine speed remains normal and the work equipment speed drops, and the pump dis- charge pressure and LS differential pressure are nor- mal, adjust the PC valve as follows. 1) Loosen locknut (4), and if the speed is slow, turn screw (5) to the right; if the engine speed drops, turn the screw to the left. # If the screw is turned to the right, the pump absorption torque will be increased, and if it is turned to the left, the pump absorption torque will be reduced.
# The adjustment range for the screw is a maximum of 1 turn to the left and 1800 to the right. # Amount of adjustment for one turn of screw: 1.5 mm movement of servo piston stroke. 2) After completing the adjustment, tighten the locknuts. Locknut (3): 34.3 ± 4.9 Nm {3.5 ± 0.5 kgm} Locknut (4): 100.5 ± 12.3 Nm {10.25 ± 1.25 kgm} 20-30