TESTING AND ADJUSTING TESTING AND ADJUSTING LS VALVE OUTPUT PRESSURE (SERVO PISTON INPUT PRESSURE) AND LS DIFFERENTIAL PRESSURE TESTING AND ADJUSTING LS VALVE OUTPUT PRESSURE (SERVO PISTON INPUT PRESSURE) AND LS DIFFERENTIAL PRESSURE # Oil temperature when measuring 45 - 550C 1. Measuring LS valve output pressure (servo piston input pressure) 1) Remove pressure measurement plugs (1) and (2) (Thread dia.=10mm, Pitch=1.25 mm), and install oil pressure gauge C1 . # Install a 39.2 MPa {400 kg/cm 2 } gauge to the servo valve end, and a 58.8 MPa {600 kg/ cm 2 } gauge to the pump outlet port end.
Oil pressure when wheels are rotating under no load on one side i) Set the working mode to heavy-duty operation mode, and turn the travel speed switch to Mi. ii) Use the work equipment to raise the wheels off the ground. iii) Measure the oil pressure with the engine at full throttle and the travel pedal operated to the end of its stroke to rotate the wheels under no load. Run the engine at full throttle, operate travel pedal to the end of its stroke, and measure the oil pres- sure when the working mode and travel speed are switched as shown in Table 1.
Table 1 20-31 Working mode Travel pedal Pump pressure MPa{kg/cm2} Servoinlet portpressure MPa{kg/cm2} Remarks H/Omode neutral 2.9±0.5 {30± 5} 2.9±0.5 {30±5} Aboutsame pressure H/Omode Full 7.8±2.0 {80±20} 3.9±1.0 {40±10} About1/2of pressure