TROUBLESHOOTING E-2 E-2 [E308] Abnormality in fuel control dial input value is displayed # This troubleshooting is carried out when there is still an abnormality, so when disconnecting the connector and inserting the T-adapter, or when removing the T-adapter and returning the connector to its original position, if the service code E is not displayed, the problem has been removed. # Before carrying out troubleshooting, check that all the related connectors are properly inserted. # Always connect any disconnected connectors before going on to the next step. Wiring harness between C03 (female) (7) - E04 (female) (1) short circuiting with ground, or contact with other wiring harness.
Table 1 E-2 Related electric circuit diagram 20-117 2 YES Is resistance between each YES pin of C03 (female) (4) (7) (17), or between each pin 1 and chassis as shown in Table 1? Is resistance between E06 (male) • Turn starting switch NO (1)-(2), (2)-(3) as OFF. show in Table 1? • Disconnect C03. • Turn starting switch OFF. NO • Disconnect E06 Cause Remedy Defective governor, pump controller Defective wiring harness in system with defective resistance Defective fuel control dial Replace Replace Replace C03 (female) E04 (male) Resistance value (7) - (4) (1) - (2) 0.25 - 7kΩ (4) - (17) (2) - (3) 0.25 - 7kΩ (7) - (17) - 2 - 3 kΩ - (1) - (3) 4 - 6 kΩ Between each pin and chassis - Min. 1 MΩ