Komatsu — E3 [ E317] Abnormality ( disconnection) in motor drive system is displayed

TROUBLESHOOTING E-3 E3 [E317] Abnormality (disconnection) in motor drive system is displayed # This troubleshooting is carried out when there is still an abnormality, so when disconnecting the connector and inserting the T-adapter, or when removing the T-adapter and returning the connector to its original position, if the service code E is not displayed, the problem has been removed. # During operation, if there is 1) a simultaneous disconnection in A phase and B phase:

1) the engine will run at low idling 2) the engine will not stop 2) a disconnection in either A phase or B phase, the engine speed will remain the same as before the abnormality occurred # If the problem occurs when the engine is stopped, 1) the engine can be started, but it stays in low idling, or 2) it will not stop after it is started. Check with the engine stopped (push the fuel control lever of the fuel injection pump to the NO INJECTION position). # Before carrying out troubleshooting, check that all the related connectors are properly inserted. # Always connect any disconnected connectors before going on to the next step.

Table 1 E-3 Related electric circuit diagram 20-118 2 YES Is resistance between YES each pin of C02 (female), or between 1 each pin and chassis Is resistance between as shown in Table 1? e (mac ah le p ),i n o ro bf eE t0 w5 een • Turn starting switch NO each pin and chassis OFF. as shown in Table 1? • Disconnect c02. • Turn starting switch OFF. NO • Disconnect E05. Cause Remedy Defective governor, pump controller Defective wiring harness in system with defective resistance Defective governor motor Replace Replace Replace E05 (male) C02 (female Resistance value (1) - (2) (2) - (3) 2.5 - 7.5 kΩ (3) - (4) (4) - (5) 2.5 - 7.5 kΩ