TESTING AND ADJUSTING H-14, H-15, H-16 H-14 In F/O modes, work equipment speed is faster than specified speed # Output pressure of LS control EPC solenoid (travel OFF). Approx. 2.5 MPa (Approx. 26 kg/cm 2 ) is output from the LS control EPC solenoid when the engine speed is approx. 1100 rmp or less in the F/O mode. (In the F/O mode, the engine speed is set at 1900 rpm when the fuel control dial is at the MAX position.) H-15 Lack of power when pressure rises H-16 In compound operations, work equipment with larger load is slow 20-223 1 YES Is output pressure of LS-EPC solenoid valve normal?
# See note 1 NO Cause Remedy Defective LS valve Defective operation of LS- EPC solenoid valve Correct or replace Correct or replace 2 YES Is output pressure of YES 2-stage relief 1 solenoid valve normal? Is oil pressure switch • Min 2.7 MPa (28 kg/cm2)NO • H/O or G/O mode normal? • Power max. mode • L.H. knob switch ON • Operate each control • Arm IN relief lever, and of NO autodeceleration is cancelled, condition is normal.
Cause Remedy Defective main relief valve Defective operation of 2- stage relief solenoid valve Defective oil pressure switch Replace Repair or replace Replace Cause Remedy Defective operation of pressure compensation valve Replace(replacepressure compensationvalveonsidewhere loadislower Combination of compound operation Sidewhereloadislarger 1. Boom RAISE + arm IN Boom RAISE 2. Boom RAISE + arm OUT Arm OUT 3. Boom RAISE + bucket CURL Boom RAISE 4. Arm OUT + bucket CURL Arm OUT 5. Boom LOWER + arm OUT Arm OUT