TESTING AND ADJUSTING TROUBLESHOOTING M-9 M-9 When starting switch is turned ON (engine stopped), basic check items flashes. # Before carrying out troubleshooting, check that all the related connectors are properly inserted. # Always connect any disconnected connectors before going on the next step. a) (coolant level) flashes # Check that the coolant is at the specified level before carrying out troubleshooting. Table Short connector Continuity Connected Yes Disconnected No M-9 a) Related electrical circuit diagram 20-249 YES 4YES 1 Does display go out Is bit (3) of YES when short con- monitoring code 24 nector is connected 3 lighted up? to P08 (female)?
Is continuity between YES C16 (female) (8) and • Turn starting switch NO • Disconnect P08. chassis as shown in ON. • Turn starting switch 2 table? • Set to monitoring ON. Is there continuity - Turn starting switch code 24. NO b (fe et mw ae le en ) (P 20 ) 8 and - O DiF sF c. onnect C16, P08 NO chassis? - Connect discon- nect short connector • Turn starting switch to P08 (female). OFF. • Disconnect P08 NO Cause Remedy Defective coolant level sensor system (See M-26) Defective governor, pump controller Defective monitor panel Defective contact, or disconnection in wiring harness between C16 (female) (8) - P08 (female) (1).
Defective contact, or disconnection in wiring harness between P08 (female) (2) - chassis ground. - Replace Replace Repair or replace Repair or replace.