Komatsu — M- 15 No abnormality is displayed on monitor but buzzer sounds.

TESTING AND ADJUSTING TROUBLESHOOTING M-14, M-15 M-14 When starting switch is turned ON (engine stopped), buzzer does not sound for 1 second. Caution item flashes but buzzer does not sound # Of the caution items, the buzzer will not sound even of there is an abnormality in the battery charge or fuel level. # Before carrying out troubleshooting, check that all the re- M-15 No abnormality is displayed on monitor but buzzer sounds. # When the buzzer sounds continuously. If the buzzer sounds intermittently, carry out troubleshooting M- 14.) # Before carrying out troubleshooting, check that all the related connectors are properly inserted. M-14, 15 Related electric circuit diagram.

20-259 lated connectors are properly inserted. # Always connect any disconnected connectors before go- ing on the next step. YES 2 When P01 (female) YES (7) and chassis are connected does 3 YES buzzer sound? 1 • Disconnect P01. Is voltage between I bs e r twes ei est na n Pc 0e 4 (male) • T Ou Nrn . starting switch NO P ch0 a4 s ( sf ie sm na ol re m) a(1 l?) and (1) and (2) normal? • Disconnect P04 NO • Turn starting switch • Turn starting switch ON OFF.

• 20-30V • Disconnect P04 • 200 - 300 Ω NO Cause Remedy Defective monitor panel Defective contact or disconnec- tion in wiring harness between P01 (female) (7) and P04 (female) (2) Disconnection, defective contact, short circuit with ground in wiring harness between P04 (female) (1) and fuse No. 13 Defective buzzer. Replace Repair or replace Repair or replace Replace # Always connect any disconnected connectors before go- ing on the next step. 1 YES When P01 is disconnected, does buzzer sounds? • Disconnect P01. NO • Turn starting switch ON. Cause Remedy Contact of chassis ground with wiring harness between P01 (female) (7) and P04 (female) (2), or defective buzzer.

Defective monitor panel Repair or replace Replace