TESTING AND ADJUSTING TROUBLESHOOTING M-17, M-18 M-17 Coolant temperature gauge does not rise # If the coolant temperature actually does not rise, check the engine system. # Before carrying out troubleshooting, check that all the related connectors are properly inserted. M-18 Coolant temperature gauge does not give any display (none of gauge lamps light up during operation) M-17, 18 Related electric circuit diagram. 20-261 # Always connect any disconnected connectors before going on the next step. YES 1 When short connector is 3 YES connected to P07 (fe- male), do level lamps on Does monitoring gauge go up in turn and YES code 41 show a then all lamps go out?
value of less than • Disconnect P07. 2 50? • Turn starting switch Is there continuity • Connect short NO ON. between C03 (female) connector to P07 (female). (1) and (16) when short • Turn starting switch ON. NO connector is connected • Set to monitoring code 41. to P07 (female)? 4 YES • Turn starting switch Is there continuity OFF. between C03 • Disconnect C03 and P07. NO (female) (1) and P 07 (female) (1)? • Turn starting switch NO OFF. • Disconnect C03 and P07.
Cause Remedy Defective coolant tempera- ture sensor system (See M-26) Defective monitor panel Defective governor, pump controller Defective contact, or disconnection in wiring harness between C03 (female) (16) - E08 (11) - P07 (female) (B) Defective contact or disconnection in wiring harness between C03 (female) (1) - E08 (6) - P07 (female) (A). - Replace Replace Repair or replace Repair or replace # Before carrying out troubleshooting, check tat all the related connectors are properly inserted. # Always connect any disconnected connectors before going to the next step. YES 1 When P07 is disconnected, does coolant temperature YES gauge display 2 appear? Is there continuity • Disconnect P07.
between C03 • T Ou Nrn . starting switch NO ( cf he am sa sl ie s) ? (1) and 3 YES Does monitoring • Turn starting switch code 41 show a OFF. NO value of less than • Disconnect C03, 50? P07. • Turn starting switch NO ON. • Set to monitoring code 41. Cause Remedy Defective coolant tempera- ture sensor system (see M- 26). Contact of chassis ground with wiring harness between C03 (female) (1) - E 08 (6) - P07 (female) (A). Detective governor, pump controller. Defective monitor panel. - Repair or replace Replace Replace