Komatsu — M- 20 Fuel level gauge does not give display

TESTING AND ADJUSTING TROUBLESHOOTING M-18,M-19 M-19 Fuel level gauge always displays FULL # Check if the tank is actually full before carrying out troubleshooting. # Before carrying out troubleshooting, check that all the re- M-20 Fuel level gauge does not give display # Check that there is actually no fuel before carrying out troubleshooting. # Before carrying out troubleshooting, check that all the re- M-19,20 Related electric circuit diagram. 20-262 lated connectors are properly inserted. # Always connect any disconnected connectors before go- ing on the next step. YES 1 When P06 is discon- nected, do level lamps in gauge go YES down in turn and then 2 all lamps go out?

Is there continuity • Turn starting switch between C02 ON. • Wait for approx. 2 NO (female) (2) and 3 YES chassis? minutes. (The fuel Does monitoring level may vary, so the • Turn starting switch code 42 show a display is given a OFF. NO value of greater than time delay) • Disconnect C02, 40? P06. • Turn starting switch NO ON. • Set to monitoring code 42. Cause Remedy Defective fuel level sensor system (see M-25) Contact if chassis ground with wiring harness between C03 (female) (2) and P06 (female) (1) Defective monitor panel Defective governor, pump controller - Repair or replace Replace Replace lated connectors are properly inserted.

# Always connect any disconnected connectors before go- ing in the next step. YES 1 Does display appear when P06 (female) 3 YES (1) and chassis ground are Does monitoring connected? YES code 42 show a 2 value of less than • • D Tuis rc no sn tan re tc int gP s0 w6. itch Is there continuity bet- 408? ON. ween C03 (female) (2) • Turn starting switch NO NO and chassis when P06 ON. (female) (1) and chassis • Set to monitoring ground are connected? code 42. • Turn starting switch OFF. NO • Disconnect C03, P06.

Cause Remedy Defective fuel level sensor system (see M-25) Defective governor, pump controller Defective monitor panel Defective contact, or disconnection in wiring harness between C03 (female) (2) and P06 (female) (1) - Replace Replace Repair or replace