Komatsu — INSTALLATION OF HYDRAULIC OIL COOLER ASSEMBLY

DISASSEMBLY AND ASSEMBLY HYADRAULIC OIL COOLER REMOVAL OF HYADRAULIC OIL COOLER ASSEMBLY Lower the work equipment completely to the ground and stop the engine. Then loosen the oil filler cap slowly to release the pressure inside the hydraulic tank. Remove the hydraulic tank strainer, and using tool B , stop the oil. When not using tool B , remove the drain plug, and drain the oil from the hydraulic tank and in- side the system. Hydraulic tank: Approx. 100 l . 1. Remove battery and set oil container under chassis. 2. Remove engine hood, then remove counterweight top cover and control valve top cover. 3. Disconnect cooler hoses (2). 4.

Remove left and right bolts (3) and (4) and left and right plates (5). 5. Sling hydraulic oil cooler assembly (6), remove 4 bot- tom mounting bolts, then lift off slowly. # When removing the hydraulic oil cooler, be ex- tremely careful not to damage the core. Hydraulic oil cooler assembly: 30 kg. INSTALLATION OF HYDRAULIC OIL COOLER ASSEMBLY Carry out installation in the reverse order to removal. 1 # Check that the O-ring is not damaged or deterio- rated, then connect the hoses. Fill with refrigerant (R-134a). Refilling with oil (hydraulic tank) # Add oil through the oil filler to the specified level. Run the engine to circulate the oil through the system. Then check the oil level again.

30-15