Komatsu — INSTALLATION OF CENTER SWIVEL JOINT ASSEMBLY

DISASSEMBLY AND ASSEMBLY CENTER SWIVEL JOINT REMOVAL OF CENTER SWIVEL JOINT ASSEMBLY Lower the work equipment completely to the ground and stop the engine. Then loosen the oil filler cap slowly to release the pressure inside the hydraulic tank. # Mark all the piping with tags to prevent mistakes in the mounting position when installing. 1. Disconnect hoses (1) and (2) between travel motor and swivel joint. 2. Disconnect pilot hoses (3), (4) and (5) and brake pipes (6) and (7). 3. Disconnect drain hoses (8) and steering hoses (9) and (10). 4. Disconnect hoses (11) (12) (13) & (14) between con- trol valve and swivel joint. 5. Disconnect steering hoses (15) and (16) and drain hose (17) 6.

Disconnect brake hoses (18) (19) and (20). 7. Disconnect travel speed selector hose (21) and sus- pension lock hose (22). 8. Remove center swivel joint assembly (23). 1 Center swivel joint assembly: 83 kg. INSTALLATION OF CENTER SWIVEL JOINT ASSEMBLY Carry out installation in the reverse order to removal. 1 Thread of swivel joint mounting bolt: Thread tightener (LT-2) Swivel joint mounting bolt: 277 ± 32 Nm (28.5 ± 3.25 kgm). Refilling with oil (hydraulic tank) # Add oil through the oil filler to the specified level. Run the engine to circulate the oil through the system. Then check the oil level again. Bleeding air # Bleed the air form the travel motor.

For details, see TESTING AND ADJUSTING, Bleeding air. 30-19