Komatsu — INSTALLATION OF TRAVEL MOTOR ASSEMBLY

DISASSEMBLY AND ASSEMBLY TRAVEL MOTOR REMOVAL OF TRAVEL MOTOR ASSEMBLY Lower the work equipment completely to the ground and stop the engine. Then loosen the oil filter cap slowly to release the pressure inside the hydraulic tank. 1. Disconnect hoses 1, 2, 3, 4, 5, 6, 7 & 8. 1 2. Remove bolts (9) and (11). 2 3. Slide away each travel motor from transmission (Use slings). # Be extremely careful not to damage the hose adaptors. 3 Travel motor assembly: Front: 45 kg Rear: 80 kg INSTALLATION OF TRAVEL MOTOR ASSEMBLY Carry out installation in the reverse order to removal. 1 Thread of travel motor mounting bolt: Thread tightener (LT - 2). Travel motor mounting bolt: Rear :

276.9 ± 31.9 Nm (28.25 ± 3.25 kgm) Front : 110.5 ± 12.5 Nm (11.25 ± 1.25 kgm) # Bleed the air from the travel motor. For details, see TESTING AND ADJUSTING, Bleeding air from travel motor. Refilling with oil (hydraulic tank) # Add oil through the oil filler to the specified level. Run the engine to circulate the oil through the system. Then check the oil level again. 30-20