Komatsu — INSTALLATION OF MAIN PUMP ASSEMBLY

DISASSEMBLY AND ASSEMBLY MAIN PUMP 13. Disconnect ground connection (15). 14. Remove exhaust drain pipe (16). 15. Remove bracket (17), then remove mounting bolts, and move governor motor bracket assembly (18) to- wards counterweight end. 16. Sling main pump assembly (19), remove mounting bolts, then use forcing screws to remove. 1 Main pump assembly: 85 kg . INSTALLATION OF MAIN PUMP ASSEMBLY Carry out installation in the reverse order to removal. 1 Mating surface of pump case: Gasket sealant (LG-6). Refilling with oil (PTO gear case) # Add engine oil through the oil filler to the specified level. Refilling with oil (hydraulic tank) # Add oil through the oil filler to the specified level.

Run the engine to circulate the oil through the system. Then check the oil level again. Bleeding air # Bleed the air from main pump. For details, see TESTING AND ADJUSTING, Bleeding air. 30-77