DISASSEMBLY AND ASSEMBLY 1ST BOOM CYLINDER REMOVAL OF 1ST BOOM CYLINDER ASSEMBLY Extend the arm, bucket and second boom fully, lower the work equipment completely to the ground, and put the safety lock lever in the LOCK position. 1. Disconnect grease hose (1). 2. Sling boom cylinder assembly (2), and remove lock bolt (3). 1 3. Remove plate, then retrack head pin (4) one side at a time, to allow each cylinder to be lowered. 2 # There are shims installed, so check the number and thickness, and keep in a safe place. 4. Start engine, and retract piston rod, then tie piston rod with wire to prevent it from coming out.
# Set stand under the cylinder assembly, and ad- just the position for slinging. Release the remaining pressure in the hydraulic cir- cuit. For details, see TESTING AND ADJUSTING, Releas- ing remaining pressure in hydraulic circuit. 5. Disconnect hoses (5). 6. Remove plate, then remove bottom pin (6), and re- move boom cylinder assembly (2). # There are shims installed, so check the number and thickness, and keep in a safe place. 3 Boom cylinder assembly: 130 kg. 30-97