DISASSEMBLY AND ASSEMBLY BOOM INSTALLATION OF BOOM ASSEMBLY Carry out installation in the reverse order to removal. 1 # When tightening the locknut, tighten so that the clearance between the plate and nut is 0.5 - 1.5 mm. 2 Inside surface of bushing when assembling pin: Anti-friction compound (LM-P). Grease after assembling pin: Grease (LM-G). When aligning the position of the pin hole, never insert your fingers in the pin hole. # Adjust the shim thickness so that the clearance between cylinder rod (11) and plate (12) is below 1 mm. # Standard shim thickness: 1.0 mm. 3 Inside surface of bushing when assembling pin: Anti-friction compound (LM-P). Grease after assembling pin:
Grease (LM-G) When aligning the position of the pin hole, never insert your fingers in the pin hole. # Adjust the shim thickness so that the clearance between boom (13) and bracket (14) is below 0.5 mm. # Standard shim thickness: 0.5 mm, 1.0 mm, 2.0 mm. Refilling with oil (hydraulic tank) # Add oil through the oil filler to the specified level. Run the engine to circulate the oil through the system. Then check the oil level again. Bleeding air # Bleed the air from the cylinder. For details, see TESTING AND ADJUSTING, Bleeding air from hydraulic cylinder. 30-124