DISASSEMBLY AND ASSEMBLY OUTRIGGER CYLINDER OUTRIGGER CYLINDER REMOVAL OF OUTRIGGER CYLINDER 1) Lower the outriggers until they just touch the ground but not take any weight of the machine. 2) Turn off the engine. 3) Depressurize the outrigger hydraulic circuit. 4) Disconnect the hydraulic lines from the cylinder. 5) Attach lifting tackle. 6) Remove bolt (2) and pin (1). 7) Remove bolts (4) and pin (3). 8) Remove cylinder. 9) Important : Depressurize cylinder before opening it. To depressurize, loosen the two plugs (5) by approx. 2 turns using an Allen key and wait until pressure has escaped. To be absolutely sure, remove the plugs completely after pressure has dropped.
INSTALLATION OF OUTRIGGER CYLINDER 1) Fit the cylinder by following the above procedure in reverse sequence. 2) Grease pins (1) and (3) before fitting. Grease bearing points after assembly. 3) Bleed air from outriggers by raising and lowering the outriggers several times. 30-125