Komatsu — INSTALLATION OF BLADE CYLINDER

DISASSEMBLY AND ASSEMBLY BLADE CYLINDER BLADE CYLINDER REMOVAL OF BLADE CYLINDER 1) Lower the blade until it just touches the ground. Do not take any weight of the machine on the blade. 2) Turn off the engine. 3) Depressurize the blade hydraulic circuit. 4) Disconnect the hydraulic lines from the cylinder. 5) Attach lifting tackle. 6) Remove bolt (2) and pin (1). 7) Remove bolts (4) and pin (3). 8) Remove cylinder. 9) Important : Depressurize cylinder before opening it. To depressurize, loosen the plugs (6) by approx. 2 turns using an Allen key and wait until pressure has es- caped. To be absolutely sure, remove the plugs com- pletely after pressure has dropped.

INSTALLATION OF BLADE CYLINDER 1) Fit the cylinder by following the reverse of the above procedure. 2) Grease pins (1) and (3) before fitting. Grease bearing points after assembly. 3) Bleed air from cylinders by raising and lowering the blade several times. 30-126