DISASSEMBLY AND ASSEMBLY OPERATOR'S CAB REMOVAL OF OPERATOR'S CAB ASSEMBLY Disconnect cable from the negative (-) terminal of the battery. 1. Remove floor mat (1). 3. Remove knob (3). 4. Remove 4 caps (4) and clip (5), then remove middle panel (6). 5. Remove bottom panel (7). # The panel is held by a clip, so remove the clip when removing the panel and be careful not to damage it. 6. Disconnect washer hose (8). 7. Remove radio (11) if fitted (refer to radio operation manual). 8. Remove plate (9), then lift cover (10) away carefully to locate speaker harness connector. Disconnect and re- move panel completely. 30-127