. OPERATION OPERATION CHECK OIL LEVEL IN ENGINE OIL PAN, ADD OIL WARNING the engine is stopped and may cause serious burns. Wait for the oil indicator is marks on the ENGINE STOPPED side of dipstick (G). If the oil is below the L mark, add oil through oil filler (F). then check the engine oil level again. 6. If the oil level is correct, tighten the handle of the oil filler cap securely. 3 - 73 Parts and oil are at high t emperature immediately after t temperature to go down be fore performing this operation. 1. Check the oil level w 2. Take out the dipstic k (G) and wipe off the oil wit 3. f 4. Fully insert dipstick When inserting, ins acing the engine. The oil level should 5.
I f the oil is above the H mark, remove drain plug ( drain valve (2) to dr REMARK When checking the o il level after the engine has been operated , wait for at least 15 minutes after stopping the engine. n angle, make it horizontal before checking. oil level marked on both sides: ENGINE STOPPED for measuring when the engine is E IDLING for measuring when the engine is idle. il level, stop the engine and check with the ENGINE STOPPED side of the dipstick. check when the engine is idle, but the following procedure must be used. ine water temperature is in the white range. DLING side of the dipstick. r cap.
If the machine is at a n angle, make it horizontal before checking The dipstick has the oil level marked on both s ides: ENGINE stopped, and ENGIN E IDLING for measuring wh en the engine i When checking the o il level, stop the engine and check wit h the ENGINE STOPPED It is also possible to check when the engine is id le, but the following procedure must • Check that the eng ine water temperature is in t he white r ange • Use the ENGINE I • Remove the oil fille