. OPERATION OPERATION STOPPING ENGINE NOTICE If the engine is suddenly stopped without allowing it to cool down, there is danger that the life of the engine parts will be shortened, so never stop the engine suddenly except in emergency. Allow the engine to cool down gradually before stopping it. 1. Set the gear shift lever to the N position, then set the parking 3 - 92 brake sw itch to the PARKING positi 2. Lower th position. 3. Run the gradually 4. Turn the key of starting switch (1) t o the OFF position t o stop the engin e. the key from starting switch (1). 5.
Remove the key from st arting switc cool down NOTICE When the mac hine is equipped with the exte rnal power source typ e electric heater and the ambient t emperature goes below -20 ° C (-4°F), run electricity from th e external po wer supply through th e engine oil pan heater and coola nt heater immediately after stopping the e ngine to prevent the temperat ure of the c oolant and engine oi l from going down. CHECKS AFTER STOPPING EN GINE 1. Walk aro of oil and 2. Fill the fu 3. Check th 4. Remove 1. Walk aro und the machin e and check the dump body, bo dy work, and undercarriage, an d check also for leakage water. el tank. e engine compartment for paper and debris.
Clean out any paper and debris to avoid a fire hazard. any mud affixed to the undercarriage. 2. Fill the fu 3. Check th e engine compartment for paper and debris. C lean out any paper and debris 4. Remove any mud affixe d to the und ercarriage