Yamaha Exciter II-570 — Inspection and Repair

INSPECTION AND REPAIR ENG 1'-1 3. Measure: • Cylinder head warpage Out of specification --+ Resurface. Warpage limit: 0.03 mm (0.0012 in) Measurement and resurfacing steps: • Attach a straight edgeCD on the cylinder head and measure the warpage using a thickness gauge ®. • If the warpage is out of specification, resur- face the cylinder head. • Place a 400 - 600 grit wet sandpaper on the surface plate, and resurface the head using a figure-eight sanding pattern. NOTE: ____________________ __ Rotate the head several times to avoid re- moving too much material from one side. CYLINDER AND PISTON 1. Eliminate: • Carbon deposits Use a rounded scraper CD .

Do not use a sharp instrument and avoid damag- ing or scratching. NOTE: ______________________ _ 2. Inspect: • Cylinder wall Wear/Scratches --+ Hone or replace. • Cylinder water jacket Crust of minerals/Rust --+ Remove. 5-7 http://ReadManuals.com