INSPECTION AND REPAIR I ENG 1'\.1 2. Install: • Piston ring (into the cylinder) Push the ring with the piston crown. NOTE: ___________ _ Insert the ring into the cylinder, and push it approximately 20 mm (0.8 in) into the cylinder. Push the ring with the piston crown so that the ring will be at a right angle to the cylinder bore. 3. Measure: • End gap Out of specification ---)- Replace rings as a ® set. Use a feeler gauge CD . Top 0.20 ... 0.40 mm (0.008 ... 0.016 in) End gap l ) ____ -- 307·027 2nd 0.20 ... 0.40 mm (0.008 ... 0.016 in) ® 20 mm (0.8 in) PISTON PIN AND BEARING 1. Inspect: • Piston Pin Blue discoloration/Grooves ---)- Replace piston pin and inspect lubrication system.
• Small end bearing Blue discoloration/Bearing turns roughly ---)- Replace bearing and inspect lubrication system. ® 2. Measure: • Outside diameter ® (piston pin) Out of specification ---)- Replace. Outside diameter (piston pin): 20.0 ... 20.005 mm (0.787 ... 0.788 in) 307·018 5-10 http://ReadManuals.com