Yamaha Exciter II-570 — Inspection and Repair

INSPECTION AND REPAIR 1 EN G 1 '--I 3. Measure: • Big end side clearance Use a feeler gauge. Out of specification ~ Replace the defective parts. Big end side clearance: 0.25 .. 0.75 mm (0.010 .. 0.030 in) 4. Inspect: • Crankshaft bearing CD Pitting/Damage ~ Replace. • Stopper ring ® Bend/Damage ~ Replace. • Crankshaft oil seals @ Wear/Damage ~ Replace. Lubricate the bearing immediately after examining them to prevent rust. CRANKCASE 1. Thoroughly wash the case halves in mild sol- vent. 2. Clean all the gasket mating surfaces and case mating surfaces thoroughly. 3. I!'spect: • Crankcase Cracks/Damage ~ Replace. OIL PUMP STROKE ADJUSTMENT 1. Pull back the rubber cover CD of the oil pump cable.

2. Remove: • Oil pump cover ® 3. Wipe off the grease from the plunger top. 5-12 http://ReadManuals.com