______________ BR_A_K_Er~~ij 3. Remove: • Stopper pin ill • Lever assembly ® Turn it clockwise. • Adjusting screw @ INSPECTION 1. Inspect: • One way lock 2 ill • Stationary cover ® Lever@ • Spiral gear @ (lever) CracksNVear/Damage ~ Replace. Replacement steps: • Remove the one way lock 2 ill using a thin flat-head screw driver. • Remove the washer ® and stationary cover ®. • Replace a damaged part(s) use a new one. • Reassemble the removed part(s) and reverse the above steps. Always use a new one way lock 2. 2. Inspect: • Torsion spring ill Fatigue/Damage ~ Replace end cover unit. Inspection steps:
• Check the fatigue ofthe torsion spring by the projection mark ® on the guide ® located between the base marks ® on the end cover @' If projection mark @ is not in the range between the base marks ® , replace the end cover unit. 4-22 http://ReadManuals.com