TRACK TENSION ADJUSTMENT I r&r I till TRACK TENSION ADJUSTMENT AWARNING A broken track, track fittings, or debris thrown by the track could be dangerous to an operator or bystanders. Observe the following pre- cautions. • Do not allow anyone to stand behind the machine when the engine is running. • When the rear of the machine is raised to allow the track to spin, a suitable stand must be used to support the rear of the machine. Never allow anyone to hold the rear of the machine off the ground to allow the track to spin. Never allow anyone near a rotating track. • Inspect track condition frequently.
Replace the track if it is damaged to the depth where fabric reinforcement material is visible. • Never install studs (cleats) closer than three inches from the edge of the track. 1. Place the machine with the right side facing down. 2. Measure: • Track deflection ® Pull at the track center window by a force of 10 kg (22 Ib) using a spring scale. Out of specification ~ Adjust. 10 kg (22 Ib) Track deflection: 25 ... 30 mm/10 kg (0.98 ... 1.18 in/22 Ib) 3. Adjust: • Track deflection Adjustment steps: • Lift the rear of the machine onto a suitable stand to raise the track off the ground. • Loosen the rear axle nut CD. NOTE:
____________________ __ It is not necessary to remove the cotter pin @ . 2-21 http://ReadManuals.com