Yamaha Exciter II-570 — Electrical

HEADLIGHT BEAM ADJUSTMENT! IINSP I Q I TAIL/BRAKE LIGHT BULB REPLACEMENT : ADJ 10. Install: • Cover (bulb holder) CD NOTE: ______________________ ___ Install the bulb holder cover so that the "TOP" mark ® faces upward. HEADLIGHT BEAM ADJUSTMENT 1. Place the machine on a level place. 2. Inspect: • Headlight beam direction The high beam should be directed down- ward at an angle of 1/2 0 to the horizontal line. If not, adjust the direction. L 3.0 m (10 ft) 7.6 m (25 ft) H 26 mm (1.0 in) 66 mm (2.6 in) 3. Remove: • Handlebar covers (rear and front) • Meter cover (See page 3-2) 4. Adjust: • Headlight beam direction Adjust the headlight beam by tightening or loosening the adjusters CD.

TAIL/BRAKE LIGHT BULB REPLACEMENT 1. Remove: • Tail/brake light lens CD 2. Remove: • Bulb (defective) ® NOTE: ______________________ __ While pushing the bulb ® , turn it counter clockwise. • Bulb (new) CD NOTE: ______________________ __ 3. Install: While pushing the bulb CD , turn it clockwise . • Tail/Brake light lens 2-27 http://ReadManuals.com