I POWTRRI~ I PRIMARY SHEAVE AND DRIVE V-BELT _ _ VUH _ LOCTITE® should be applied only to the area specified. Never apply to the bushings and other areas. 3. Install: • Fixed sheave stoppers CD NOTE: ______________________ ___ Stoppertapered portion should face fixed sheave. 4. Tighten: • Spider Tightening steps: • Finger-tighten the spider until it stopped by fixed sheave stopper. • Hold the fixed sheave with the Clutch Spider Separator (-, YS-28890-8) CD . NOTE: ______________________ _ Securely fit the projections of the Clutch Sepa- rator Adapter ® into the fixed sheave holes. • Tighten the spider to specification using the bar wrench ® . Spider:
200 Nm (20 m • kg, 145 ft· Ib) Spider has a left-hand thread. AWARNING Do not operate the primary sheave until the LOCTITE® has dried completely. Wait 24 hours before operating primary sheave. • Since the tightening torque is high, make sure the spider, fixed sheave, and special tool are placed securely. Tighten the spider carefully to prevent cracks and/or damage to the sheaves and spider. 4-7 http://ReadManuals.com