Transmissions vehicle is moving. Preselection with the range preselection lever must be made prior to moving the shift lever out of gear into neutral. 5. For 10-speed transmissions: When ready for the next upshift, move the deep reduction button rearward, then break the torque on the gears by momentarily releasing the accel- erator or depressing the clutch pedal. Do not move the shift lever. 10. After your shifting ability improves, you may want to skip some of the ratios. This may be done only when operating conditions permit, depend- ing on the load, grade, and road speed. Upshifting For 15-speed transmissions:
There are several patterns of upshifting, depending on the vehicle load and the road conditions. See Table 8.2 for suggested shifting sequences. Deep reduction gears are best suited for heavy loads and steep inclines. Low gear (in 10-speed transmissions) is best suited for off-highway use. Shift upward from 1st gear of deep reduction to 5th gear of deep reduction, double-clutching be- tween shifts and accelerating to 80 percent of engine governed speed. See Table 8.2 . When ready for the next upshift, move the deep reduction button from the forward position to the rearward position, then double-clutch through neutral, and move the shift lever to the 4th gear position in the low range.
The following instructions are recommended for start- ing a loaded vehicle moving, under adverse condi- tions. 6. Shift upward from low gear (10-speed transmis- sions) or 4th gear (15-speed transmissions), to the top gear in low range ( Table 8.2 ), double- clutching between shifts, and accelerating to 80 percent of engine governed speed. 1. Position the gear shift lever in neutral. Start the engine, and bring the vehicle air system pressure up to 100 to 120 psi (689 to 827 kPa). 2. Position the range preselection lever down, into low range. 7. While in the top gear of the low-range shift pat- tern, and ready for the next upshift, flip the range preselection lever up into high range.
Double- clutch through neutral, and shift into the bottom gear in high range ( Table 8.2 ). As the shift lever passes through neutral, the transmission will au- tomatically shift from low range to high range. 3. Move the deep reduction button to the forward position, to engage the deep reduction gears. 4. Depress the clutch pedal to the floor. Shift into low-low gear (10-speed transmissions) or 1st gear of deep reduction (15-speed transmissions); then engage the clutch, with the engine at or near idle speed, to start the vehicle moving. Ac- celerate to 80 percent of engine governed speed.
DEEP REDUCTION LOW RANGE HIGH RANGE Adverse Conditions Only Off-Highway and Adverse Conditions On-Highway and Ideal Conditions All Conditions Eaton Fuller Shift Progressions TRANSMISSION MODEL R 2 5 R 2 5 R 2 5 R 7 10 15-Speed RTO DR DR Lo Lo Lo Lo 6 8 9 3 1 DR DR DR f260341 4 Lo Lo Lo 1 3 f260342 4 Lo Lo 1 3 4 f260343 Lo f260344 R 2 DR DR 4 R Lo Lo 4 2 R Lo Lo 2 4 R 7 6 15-Speed RT and RTX DR DR DR 1 3 5 Lo Lo Lo 3 5 1 Lo Lo Lo 1 3 5 6 8 10 f260345 Table 8.2, Eaton Fuller Shift Progressions f260346 f260347 f260348 8.9