Freightliner FLD Conventional — FLD Conventional

Transmissions 8. With the transmission in high range, shift pro- gressively upward through each of the high range gears ( Table 8.2 ), double-clutching be- tween shifts. General Information, Super 10/Top 2/Lightning Super 10, Top 2, and Lightning transmissions have 10 selective forward ratios and a 2-speed rear sec- tion. Half of the 10 speed ratios are shifted with the shift lever and the other half are shifted by moving the shift button. See Fig. 8.8 for the Super 10 and Top 2 shift knob, and Fig. 8.9 for the Lightning shift knob.

Alternate Upshifting Procedures (15- Speed Transmissions Only) The shift from deep reduction to low range can also be made from 2nd, 3rd, or 4th gear of deep reduc- tion, but must be made to the next gear lower in the low range. The shift from 2nd gear of deep reduction to 1st gear in low range (or 3rd gear of deep reduc- tion to 2nd gear in low range, and 4th gear of deep reduction to 3rd gear in low range), is an upshift, and the same procedure should be followed as that shown for shifting from 5th gear of deep reduction to 4th gear in low range. See step 5, under "Upshifting." B Fuller Downshifting A Fuller 1.

With the transmission in high range, shift pro- gressively downward to the bottom gear in high range, double-clutching between shifts. C 09/25/96 f260399 A. Shift Button B. Gears 2, 4, 6, 8, 10 when button is forward C. Gears 1, 3, 5, 7, 9 when button is rearward 2. When in the bottom gear of the high-range shift pattern, and ready for the next downshift, push the range preselection lever down into low range. Fig. 8.8, Super 10 and Top 2 Shift Knob Double-clutch through neutral, and shift into the top gear of the low-range shift pattern. As the shift lever passes through neutral, the transmis- sion will automatically shift from high range to low range. 3.

With the transmission in low range, downshift through the low range gears, as conditions re- quire. 1 IMPORTANT: Never use the clutch brake when downshifting, or as a brake to slow the vehicle. Eaton Fuller Super 10, Top 2, and Lightning Semi-Automated Transmissions 2 09/12/2002 f261190 Refer to the Eaton website for additional information, www.roadranger.com. 1. Shift Button 2. Service Light Fig. 8.9, Lightning Shift Knob There are three types of shifts used with these trans- missions. Button-only and combination button/lever shifts are both full gear changes. The lever-only shift skips a gear. 8.10