Transmissions The button-only shift is a gear split shift that occurs by moving the shift button. The lever-only shift occurs when the shift lever is moved without moving the shift button. HI R 4 8 LO 3 7 The combination button/lever shift is a gear ratio change that occurs when both the shift button and the shift lever are moved. R NEUTRAL The small red service light on the Lightning shift knob illuminates for a few seconds when the engine is turned on. This confirms that the transmission electronics are operating properly. 2 6 5 A U T O 1 NOTE:
If the service light stays on or flashes, or does not illuminate when the engine starts, take the vehicle to an authorized Freightliner or Eaton service facility as soon as possible. 12/14/1999 f261054 Fig. 8.11, Top 2 and Lightning Shift Patterns (with cruise control on) See Fig. 8.10 for the Super 10 shift pattern, which is also used by Top 2 and Lightning when the cruise control is off. Top 2 and Lightning transmissions are equipped with the Top 2 feature that allows the trans- mission, with cruise control on, to automatically shift between the top two gears (9th-10th) without the need for a button-only shift. See Fig. 8.11 .
Operation, Super 10/Top 2/Lightning CAUTION Keep the transmission in gear at all times while the vehicle in motion. Coasting in neutral could lead to transmission damage. 1. When operating off-highway, or under adverse conditions, always use low gear (if so equipped) when starting to move the vehicle. HI LO R R 4 3 8 7 When operating on-highway, with no load, or under ideal conditions, use 1st gear when start- ing to move the vehicle. N 1 2 6 5 10 9 For all conditions, use the highest gear that is still low enough to start the vehicle moving with engine idling, and without slipping the clutch ex- cessively. 09/24/96 f260397 NOTE:
The Top 2 and Lightning transmissions use the Super 10 shift pattern when cruise control is off. 2. Use the clutch brake to stop gear rotation when shifting into 1st or reverse when the vehicle is stationary. The clutch brake is actuated by de- pressing the clutch pedal all the way to the floor. Fig. 8.10, Super 10 Shift Pattern IMPORTANT: Not all lever positions are used in each range and the shift patterns vary between transmis- sions. Be sure to read the shift pattern decal on the dash for the operating instructions for the specific transmission installed in your vehicle. For normal upshifts and downshifts, only a partial disengagement of the clutch is necessary to break engine torque. 3.
Do not make range shifts with the vehicle moving in reverse gear. 4. The shift lever should not be moved to the center or left rail positions at vehicle speeds above 40 mph (65 km/h). 8.11