Freightliner FLD Conventional — FLD Conventional

Transmissions above 1400 rpm). Doing so could result in dam- age to the engine, transmission, and/or driveline. to be engaged while the transmission is in neu- tral during a gear change. 3. Combination button/lever shift—With the throttle still applied, preselect the next gear by sliding the shift button forward. Break torque by releas- ing the throttle and depressing the clutch pedal. Double-clutch and move the shift lever to the next desired gear position. The combination button/lever shift is used for gear changes from 9th to 8th, 7th to 6th, 5th to 4th, and 3rd to 2nd.

1 A 2 Eaton Fuller AutoShift Automated Transmissions SOLID 3 Refer to the Eaton website for additional information, www.roadranger.com. SOLID 4 FLASHING General Information, AutoShift 18-Speed RTLO Models 5 02/17/98 f270062 B A. Gear Display Module B. Module Detail 1. Current Gear 2. 9th Gear Engaged 3. In 9th Gear, Preselected Toward 10th 4. Out Of Gear, Waiting For Engine/Transmission rpm To Synchronize 5. 10th Gear Engaged SOLID Eaton Fuller 18-speed RTLO model transmissions have 18 forward speeds and four reverse speeds. The transmission consists of a 5-speed front section and a 3-speed rear section. The driver must use the clutch to start and stop the vehicle.

10-Speed RTO Models Eaton Fuller 10-speed RTO model transmissions have 10 forward speeds and two reverse speeds. The transmission consists of a 5-speed front section and a 2-speed rear section. The driver must use the clutch to start and stop the vehicle. Fig. 8.12, Gear Display Module The Driver Command Console (DCC) replaces the shift lever and controls the transmission’s shift patterns. On newer models, the Smart- Shift controller replaces the DCC. If your ve- hicle is equipped with a SmartShift controller, see the information under the heading "Freight- liner SmartShift Transmission Shift Control." Both 10- and 18-speed AutoShift models are partially automated transmissions.

The driver does not need to break torque or increase or decrease engine speed to synchronize the shift. The transmission sig- nals the engine controller when to break torque and the engine controller automatically increases or de- creases engine speed. When engine speed is cor- rect, the transmission engages the next gear and signals the engine controller to resume operation. The Standard DCC ( Fig. 8.13 ) has indicators for the three forward positions: Drive, Low (2nd gear), and Low1 (1st gear), plus Reverse and Neutral positions. Service and wait lamps are also located on the console. The gear select handle contains only a gear select lever detent button.

The AutoShift system consists of the following com- ponents: The Gear Display Module ( Fig. 8.12 ), mounted on the dashboard, indicates the current gear position. The display also flashes the next gear The Enhanced DCC ( Fig. 8.14 ) has indicators for the three forward positions: Drive, Hold, and Low, plus Reverse and Neutral positions. Service and wait lamps are also located on the 8.13