Transmissions The Electronic Control Unit (ECU) includes two controllers: a transmission ECU and a system ECU. The transmission ECU controls all trans- mission shift functions and the system ECU manages all vehicle interfaces for transmission shift functions. R N 1 SERVICE D An electronic range valve, controlled by the transmission ECU, is used to perform range shifts. 2 3 WAIT HOLD L L1 B Operation, AutoShift 02/16/98 f270063 A WARNING A. Console Top View B. Select Handle Side View 1. Indicator Lamps 2. Gear Position Indicator 3. Detent Button If the engine cranks in any gear other than neu- tral, have the vehicle serviced immediately.
If the vehicle is started in gear it will suddenly move forward or backward, which could result in per- sonal injury and damage to property and the transmission. Fig. 8.13, Standard Driver Command Console (DCC) Start-Up R 1. With the parking brake applied, press the clutch all the way down to the floor. N 3 2. Start the engine. 1 SERVICE WAIT D 5 3. Check to make sure the transmission is in neu- tral. L 2 HOLD H 4 B 4. With the transmission in neutral, release the clutch. NOTE: This allows the speed sensor on the input shaft to get a reading. 02/16/98 A f270064 5. Press down on the clutch again and release the parking brake. A. Console Top View B. Select Handle Side View 1. Indicator Lamps 2.
Gear Position Indicator 3. Upshift Button 4. Detent Button 5. Downshift Button 6. Select the desired starting gear. Fig. 8.14, Enhanced Driver Command Console (DCC) 7. Release the clutch. console. The gear select handle contains up- shift and downshift buttons and a gear select lever detent button. Reverse NOTE: To drive in reverse, first depress the clutch. The shifter performs shifts at the front portion of the transmission. It preselects the shift to neutral and completes the gear change after driver input. 1. Move the gear select lever to the "R" position. 2. On 10-speed models, select either LO or HI re- verse by depressing either the downshift or up- shift button ( Fig.
8.14 ) on the gear select handle (if equipped). 8.14