Transmissions On 18-speed models, four reverse gears are available. Select either low range, low split (1R); low range, high split (R); high range, low split (1H); high range, high split (H). 1. With the vehicle stopped, place the gear select lever in the "D" or "H" position to select a starting gear. 3. Release the clutch. 2. Select the starting gear with the upshift or down- shift buttons on the gear select handle. NOTE: The clutch must be used for starting and stopping. Driving in the "H" Mode (if equipped) NOTE: You must use the upshift and downshift buttons on the gear select handle to change gears while in the "H" (hold) mode. Driving in the "D" Mode NOTE:
The drive mode is used for normal driv- ing conditions. 1. Depress the clutch pedal. 1. Fully depress the clutch. 2. Place the shift lever in the "H" mode. 2. Move the gear select lever from neutral to drive. 3. Select the starting gear you want. NOTE: The clutch must be fully depressed to shift from neutral to drive. 4. Slowly release the clutch pedal. Upshifting 3. Upshifting and downshifting are performed auto- matically with no driver interaction required. NOTE: In the "H" mode you, the driver, decide when to upshift and downshift. NOTE: The clutch must be used for starting and stopping. 1. Accelerate. 2. Press the upshift button on the gear select handle. To skip shift, press twice.
Parking the Vehicle 1. With the clutch pedal depressed, move the gear select lever to neutral. 3. The transmission automatically selects and shifts to the next gear. 2. Ensure that a solid "N" appears on the gear dis- play module. See Fig. 8.12 . Downshifting NOTE: If the gear display does not show a solid "N," the transmission is not yet in neutral. 1. Decelerate. 2. Press the downshift button on the gear select handle. To skip shift, press twice. 3. Set the parking brakes. 3. The transmission automatically selects and shifts to the next gear. 4. Slowly release the clutch pedal. Selecting the Starting Gear (push button equipped gear select handle only) Spicer Straight-Shift Models NOTE:
On vehicles equipped with upshift and downshift buttons ( Fig. 8.14 ) on the gear select handle (enhanced DCC), you may select the starting gear. The gear you select is only active while the vehicle is running. The transmission resets to the default starting gear after you have shut off the engine. Depending on the vehicle’s load, you may select gears 1 through 5 as the starting gear. Refer to the Spicer/TTC website for additional infor- mation, www.ttcautomotive.com. General Information, Spicer Straight- Shift Spicer 7-speed series transmissions are synchro- nized in all gears except 1st and reverse. They have seven forward gears and one reverse gear. See Fig. 8.15 for the shift pattern.
8.15