Transmissions 1. Depress the clutch pedal enough to release the torque, shift into the next lower gear, and engage the clutch smoothly while accelerating the engine to keep the vehicle moving at the desired speed. R 2 4 6 2. Continue downshifting, as conditions require, using the same sequence described above. When shifting down into 1st gear, remember that 1st gear isn’t synchronized. Double-clutch when shifting down into 1st gear. N 5 1 3 7 IMPORTANT: Never use the clutch brake when downshifting, or as a brake to slow the vehicle. 03/12/96 Fig. 8.15, Spicer 7-Speed Transmission Shift Pattern f260118 Operation, Spicer Straight-Shift Meritor Range-Shift Models 1.
Always use 1st gear when starting to move the vehicle forward. Refer to the Meritor website for additional informa- tion, www.arvinmeritor.com. 2. Use the clutch brake to stop gear rotation when shifting into 1st or reverse when the vehicle is stationary. The clutch brake is actuated by de- pressing the clutch pedal all the way to the floor. For normal upshifts and downshifts, only a partial disengagement of the clutch is necessary to break engine torque.
General Information, Meritor Range- Shift Range-shift transmissions are typically upshifted by moving the shift lever through all of the low gear po- sitions and then activating a range switch to provide an additional set of ratios in the high range using the same shift lever positions as used in low range. The shift lever then is moved sequentially through each position as before but all the positions now provide a higher gear ratio. The initial low gear is often used only in low range. 3. Double-clutch only when shifting out of neutral, or when shifting down into 1st. Upshifting 1. Position the gear shift lever in neutral, then start the engine.
Bring the air system pressure up to 100 to 120 psi (689 to 827 kPa). IMPORTANT: Not all lever positions are used in each range and the shift patterns vary between transmissions. Be sure to read the shift pattern decal on the dash for the operating instructions for the specific transmission installed in your vehicle. 2. Press the clutch pedal to the floor. Shift into 1st gear, then engage the clutch, with the engine at or near idle speed, to start the vehicle moving. Accelerate to engine governed speed. 3. Once governed speed has been attained, disen- gage the clutch enough to break torque, and move the shift lever to 2nd gear.
Then engage the clutch, and accelerate back to engine gov- erned speed. 9-Speed Models Meritor 9-speed M, MO, RM, RMO, and RMX model transmissions have a 5-speed front section, and a 2-speed auxiliary section. The low gear in the front sections of the "A" and "B" ratio transmissions is used only as a starting ratio. The high gear in the front section of the "R" ratio transmissions is used only as the top gear. The remaining gear positions of the above transmissions are used once in the low range and once in the high range. 4. Continue shifting upward, using the same se- quence described in step 3 above. See Fig. 8.15 for the shift pattern.
Downshifting When downshifting, shift progressively down through each successive lower gear, as follows: See Fig. 8.16 for the shift patterns. 8.16