Transmissions A B C 5 7 3 1 4 5 8 8 6 2 1 1 4 N N N 8 6 2 6 7 3 2 9 5 7 3 2 4 1 03/13/96 f260156a A. All Standard "A" and "B" Ratios B. RMO Models with "A" and "B" Ratios C. All "R" Ratios 1. Up for High Range 2. Down for Low Range Fig. 8.16, Meritor 9-Speed Transmission Shift Patterns NOTE: The 3rd/7th and 4th/8th shift positions in the standard "A" and "B" ratio transmissions (both direct drive and overdrive) are opposite of the RMO model (overdrive only) transmissions. NOTE: The 4th/9th and 5th/10th shift positions in the standard "A" and "B" ratio transmissions (both direct drive and overdrive) are opposite of the RMO model (overdrive only) transmissions.
The "R" ratio transmissions have the 1st/5th shift po- sitions where low is in the "A" and "B" ratio transmis- sions. The top gear in the "R" ratio transmissions is called 9th gear. Operation, Meritor Range-Shift Reverse 10-Speed Models To drive in reverse, push the range selector lever down to put the transmission in the low range. Push the clutch pedal to the bottom of travel so the clutch brake slows the transmission for initial gear engage- ment. Holding the clutch pedal at the bottom of travel, shift into reverse. Meritor 10-speed transmissions have ten evenly- spaced forward ratios. Each transmission consists of a 5-speed front section, and a 2-speed auxiliary sec- tion.
The ten forward speeds are obtained by twice using a 5-speed shift pattern: the first time in low range, the second time in high range. See Fig. 8.17 for the shift patterns. Slowly release the clutch pedal to move the vehicle in reverse. Upshifting A B 1. To drive forward, make sure the vehicle is com- pletely stopped and the range selector lever is pushed down to put the transmission in the low range. 4 7 2 9 7 2 10 5 N N C Push the clutch pedal to the bottom of travel so the clutch brake slows the transmission for initial gear engagement. Holding the clutch pedal at the bottom of travel, shift into low. D 6 1 8 3 10 5 6 1 8 3 9 4 03/13/96 f260155a 2.
Slowly release the clutch pedal to begin moving the vehicle forward. A. All Standard Models B. RMO Models Only C. Up for High Range D. Down for Low Range 3. To upshift into 1st gear, only partial depression of the clutch pedal is needed. Do not push the clutch pedal all the way to the floor and engage the clutch brake; instead, partially depress the Fig. 8.17, Meritor 10-Speed Transmission Shift Patterns 8.17