Engines and Clutches The information below contains guidelines for cold- weather starting. For additional information, refer to "Ether Start System." WARNING Do not use any starting aid, such as ether, in en- gines with an intake air preheater. This could cause an explosion, resulting in serious personal injury or death. 1. Before engine start-up, perform the engine pre- trip inspection and daily maintenance checks in Chapter 11 . 09/21/2006 f610844 2. Set the spring parking brakes. Fig. 7.4, Request/Inhibit Regen Switch 3. Turn the ignition switch to the on position.
All the electronic gauges on the ICU (instrumentation control unit) complete a full sweep of their dials, the warning and indicator lights light up, and the buzzer sounds for three seconds. CAUTION When starting a vehicle equipped with a manual transmission and clutch lockout switch, the clutch pedal must be fully depressed during the entire start sequence. Failure to do so can cause the pinion to release and re-engage, which could cause ring gear and starter pinion damage. NOTE: The engine electronics supply the cor- rect amount of fuel for starting the engine. Pedal pressure is unnecessary. 4. Turn the ignition switch to the start position. Do not press down on the throttle pedal.
Release the switch the moment the engine starts. If the engine does not start after 30 seconds of crank- ing, turn the ignition switch off. If a vehicle does not start on the first attempt, make sure that the engine has completely stopped rotating before reapplying the starter switch. Failure to do so can cause the pinion to release and re-engage, which could cause ring gear and starter pinion damage. NOTE: Some starters are equipped with op- tional overcrank protection. If overcranking oc- curs, a thermostat breaks the electrical circuit to the starter motor until the motor has cooled. For air start systems, check the air supply before starting the engine.
There must be 100 psi (689 kPa) of air pressure available. Moving a vehicle with the starter and/or using the starter to bump the engine for maintenance pro- cedures is strictly prohibited. Use of these meth- ods to bump the engine over or move the vehicle can cause the pinion to release and re-engage, which could cause ring gear and starter pinion damage. 5. Wait two minutes to allow the starter motor to cool. Turn the ignition switch back to the on posi- tion and try to start the engine again. IMPORTANT: Ring gear and starter pinion dam- age caused by improper starting procedures is not warrantable.
CAUTION Caterpillar If the oil pressure is less than 5 psi (35 kPa), shut down the engine immediately to prevent serious damage. If the vehicle is equipped with an auto- matic shutdown system, the engine will shut down after 30 seconds. NOTE: Before starting the engine, read Chap- ter 2 in this manual for detailed information on how to read the instruments and operate the controls. 7.3