Freightliner FLD Conventional — FLD Conventional

Engines and Clutches 1. Disconnect the wire from the fuel pump solenoid valve. terfront to allow airflow through the entire charge-air-cooler core. Do not use a winterfront with closed areas that block uniform air flow across any sections of the charge-air-cooler crossflow tubes. This will adversely affect the operation and durability of the charge air cooler. 2. Crank the engine until oil pressure shows on the gauge. 3. Connect the wire to the fuel pump solenoid valve. 4. Start the engine. Refer to "Engine Starting" above.

Caterpillar If the engine is in good mechanical condition and the precautions necessary for cold-weather operation are taken, ordinary cold weather will not cause difficulty in starting, or loss of efficiency. Ether Start System Ether allows combustion with lower cylinder tempera- tures. A pressurized spray-can or a rag dampened with fluid will usually provide quick starting to as low as (–23°C). Below this temperature, some means of injecting a carbureted vapor directly into the intake manifold is necessary. If the engine does not start, prime the fuel system. When the use of unblended No. 2 diesel fuel in win- ter cannot be avoided, install a thermostatically con- trolled fuel heater.

Fuel heaters can prevent wax from clogging the fuel filters and formation of ice crystals from water in the fuel. Caterpillar truck engines with direct injection are de- signed to start at temperatures above 10°F (–12°C) without using start systems. If the temperature is below 10°F (–12°C), a start system may be neces- sary and/or crankcase oil may need to be heated. Jacket water heaters are often used to assist starting in cold temperatures. IMPORTANT: If a fuel heater is used, make sure it has thermostatic controls to prevent excessive heating of the fuel in warm weather. Excessive heating of fuel can cause a loss of engine power.

The cold start system, approved for use on Cummins engines, has been based upon starting aid capabili- ties to (–32°C). For cold-weather operation, use the following guide- lines: 1. When starting the engine in temperatures below 32°F (0°C), use engine lubricants of lower vis- cosity. See your engine operation and mainte- nance manual for specifications. WARNING If using a cold-weather-start system, be sure to follow the manufacturer’s instructions regarding its use, handling, and storage. Many starting flu- ids are in capsules or pressure cans, and im- proper usage can be dangerous. 2.

When the temperature is below freezing, use suf- ficient antifreeze solution in the cooling system to prevent freezing. Refer to Group 20 of the Heavy-Duty Trucks Maintenance Manual for specifications. Do not attempt to use any type of vapor- compound start system near heat or open flame. Engine damage due to an explosion or fire in the intake manifold could result. 3. During cold weather, give more attention to the condition of the batteries. Test them frequently to ensure sufficient power for starting. Inspect all switches and connections in the electrical system and keep them in good condition to prevent losses through poor contacts.

See Group 15 of the Heavy-Duty Trucks Service Manual for de- tailed information. Do not breathe the ether fumes; doing so could result in personal injury. Cold-Weather Operation IMPORTANT: If a winterfront is used on a ve- hicle with an electronic engine equipped with a charge air cooler, make sure that there are slit openings distributed across the face of the win- WARNING Do not use any starting aid, such as ether, in en- gines with an intake air preheater. This could 7.5